Reta injection probs?

Hong Kong Yanpep International
the pressure buildup in sealed vials is the one that catches people by surprise - if you inject air in to draw without releasing the vacuum first, or if the vial has been warming and you inject cool liquid against pressure, the stopper can push back hard. scoring the crimp ring partially rather than removing it completely and using a vent needle or slow equalization technique prevents the blowback
 
drawing cold from the fridge is fine for most compounds - the viscosity is slightly higher but not enough to meaningfully slow the fill on a 30g+ needle. the convenience of not waiting for warm-up is worth it for most people, and there's no reconstitution stability benefit to a few minutes at room temp. the only case where warming matters is when sting on injection is a persistent problem
 
Thanks! What I need is 31g x 1 inch for intramuscular. I'll switch to pens for peptides anyway, so its moot; the needles were mainly for TRT, and I keep flipping between IM and subq depending on which doctor I listen to about effectiveness. I'm not putting a 27ga or bigger needle in my muscle. So Im testing what works for drawing from the vial versus injecting. BD Precision Glide was somewhat pricey at $45 per box of 100, but the Amazon brands all show inkjet cartridge pictures, maybe just legal cover, and I am unsure I want to gamble to save a few bucks. Easy Touch in 1 inch 30ga would be ideal, yet that size stops at half an inch.
 
I know the feeling, same for me. I keep staring at mine and haven't reconstituted it yet. The trick I liked most: pull your dose, top the syringe up with BAC water so it's diluted, and push slowly. For tiny doses, 500mcg or below, I grab the little 30 unit syringes with a 5/16 inch needle if possible. For GHK cu I'll probably grab the bigger 100 unit one so I can dilute more, at least at first. That needle runs a half inch but it's no problem. The 30 unit one wins for tiny doses since it's quicker to dial in accuracy.
 
Shopping for reconstitution needles at the moment, any advice? The research ones would probably be fine, but a bigger gauge with a longer needle looks like the best pick. Also curious whether a tried and tested reconstitution needle exists already.
 
Pinching a bit of skin, I go in straight, without an angle. I'm curious how the 6mm goes, tell me. Those sound fine, what mg do you run? 31g needles are great, but pulling liquid out of vials into the syringe can drag, and vial vacuum isn't the reason, which I learned a couple of pins back after blaming myself. Leaving the vials out to warm up for a while helps. A couple hundred of them sit in my stash so I'll just get used to waiting a few seconds more. Filling was way easier with my 30g.
 
You must log in or register to reply here.
Back
Top