Mixing BAC... how much?

Hong Kong Yanpep International
The homemade BAC water approach using pharmaceutical-grade benzyl alcohol and USP sterile water is technically sound if the final concentration lands at 0.9% - the filling step is where contamination risk is highest, and clean technique when piercing seals is essential. Most people find purchasing pharmaceutical-grade BAC water more practical than mixing their own.
 
sterile water works fine if BAC isn't available - the tradeoff is that working stock reconstituted in sterile water needs to be used faster, since there's no bacteriostatic preservation. for short-term use or if you're going through vials quickly that window isn't a problem. the DIY BA addition approach is something people do but the concentration needs to be right to actually be effective
 
2ml in a 10mg vial is the standard starting point for most reconstitution - it gives you a 5mg/ml concentration that makes the math easy. 1ml works if you're using tiny doses and want more precise small measurements, but 2ml is more forgiving if you're dosing in the typical range. You gotta decide which calculation you'd rather be doing every injection.
 
the transfer-and-dilute approach after initial reconstitution is useful when working with higher concentration formulations - moving to a larger vial and adding more carrier fluid after reconstituting lets you pull smaller, more precise volume doses without having to work with tiny fractions on the syringe. the filter step during transfer is the important one for removing any particulate from the initial reconstitution
 
Starting at 2mg is the standard conservative approach for first-time reconstitution. The 5mg vial question usually comes down to flexibility - smaller vials give you more control over concentration until you know how you respond. BAC water volume to vial size is the ratio to nail down early. What concentration are you planning to work with?
 
Here's my mix, 3mL of BAC water total. 10 units works out to about 1.667mg split three ways, and 12 units gets you near 2.0mg the same way. Never had pain or irritation, and that 3ml load fits fine in a pen.
 
This is the specific item purchased, comes in five and ten milliliter options too. Typically use the three milliliter size, though the larger ones are on hand as well.
 
I've got a reconstituted bottle at 500mg, mix it with 3ml, no problems at all. Got some 1000mg coming and planning to use 6ml for that one. Sorry you're running into issues though.
 
Yeah, no worries at all. First time mixing anything I meant to add roughly two milliliters, but instead accidentally spilled some diluent onto the counter, most of it made it into the vial though, so I just estimated I'd landed around 1.6 milliliters into my twenty-milligram vial. Lost weight fine and had zero trouble moving on to my next vial after, so I figure my guess was close enough. You'll be totally fine.
 
You're not being dumb, I'm just genuinely confused here.

So you're saying the concentration works out to 10mg in every milliliter of diluent?

And now you want to add yet another milliliter on top? What does the actual vial label say?
 
So your amount would come out to 3.75, and with a 30mg vial strength that gives you eight total doses... the diluent volume determines how much you're actually injecting per shot.
And honestly the only bad question is the one you're too scared to ask.
There'll always be a few smug jerks ready to mock you for asking (seems way more common in certain other threads than here), ignore them completely. Ask whatever you need.
 
You must log in or register to reply here.
Back
Top